Chaw_2003_Biomaterials_24_1271

Physostigmine is an anti-cholinesterase used for the pretreatment of a poisoning caused by highly toxic organophosphorus neurotoxins. The aim of this study is to design a polymeric microparticle system for sustained release of physostigmine. In this paper, we have attempted to encapsulate physostigmine in microparticles made from poly(D,L-lactide-co-glycolide) (PLGA) with various contents of glycolide and poly(D,L-lactide) (PLA) using spray-drying and single emulsion techniques. It was found that during the single emulsion process, most of the physostigmine molecules were lost in the external aqueous phase. However, more than 90% encapsulation efficiency of physostigmine was obtained using the spray-drying technique. SEM micrographs revealed that spherical microparticles containing physostigmine with a smooth surface were yielded with PLA, PLGA 50:50, RG 502 (PLGA 50:50 with a lower molecular weight) and PLGA 65:35 but PLGA 85:15, PLGA 75:25 and PLGA 50:50 with a high concentration produced microparticles with irregular shapes. An increased inlet temperature yielded a higher physostigmine release rate from the PLA microparticles. Physostigmine release from the microparticles showed a biphasic pattern, characterized by an initial burst release followed by a sustained release for PLGA 65:35, PLGA 50:50 and RG 502 or a non-detectable release for PLGA 85:15, PLGA 75:25 and PLA. A sustained-release of physostigmine with a low initial burst over 1 week was achieved from RG 502 microparticles, which would be used as an injectable dosage form in our further animal studies.