Yang_1997_Biotechnol.Bioeng_56_671

Lipase from Candida rugosa immobilized on a nylon support has been used to synthesize lovastatin, a drug which lowers serum cholesterol levels, by the regioselective acylation of a diol lactone precursor with 2-methylbutyric acid in mixtures of organic solvents. Analogs of lovastatin having a different side chain were also obtained through this method by reacting the diol substrate with different carboxylic acids. The selection of reaction conditions that maximize the initial reaction rate is investigated. Since the diol substrate has very low solubility in non-polar solvents, reaction solvents consisting of mixtures of hexane with a different, more polar cosolvent are considered. For each of the cosolvent mixtures studied, the reaction rate is maximum for an intermediate percentage of cosolvent in hexane. With total concentrations of the diol lactone in the range 6.25-12.5 mM, maximum initial rates correspond approximately to those cosolvent concentrations that permit a complete solubilization of the substrate. At higher cosolvent concentrations, lower rates are obtained. When considering the same dissolved substrate concentration, the reaction rate was found to increase with increasing values of logP(mix) and decreasing values of the dielectric constant, when varying the composition of a binary solvent mixture. However, when comparing different cosolvents, no general trend with respect to these properties was observed. (c) 1997 John Wiley & Sons, Inc. Biotechnol Bioeng 56:671-680, 1997.